Engineered G-Clips

/Engineered G-Clips
  • Model GG-0 "Short-Grip"
    Fits 1" tall grating and minimal thickness beam edge. GG-0 also may fit 3/4" tall grating and 1/4" beam edges. (Samples are offered to confirm in each case of 3/4" grating and any beam thickness) Model GG-0 Info Page
  • Attach devices to grating surface

    Model GM-1/2 Available in Galvanized Carbon Steel. Model SSGM-1/2 Available in 316-Stainless Steel. The model GM-12 describes an assembly of fastener parts that can be used as a stable base on which to mount other devices to a grating surface. Assembly consists of a 1/2 " stud about 3 " long, which contains a patented bottom part that holds captive a 1/2" nut. The top part is a generous-sized plate with a 1/2" diameter threaded hole, which sits above the grating, and is tightened down to complete the fastener installation. This provides a remaining stud length above the grating onto which can be fastened devices as desired.
  • Attach Close-Mesh grating to structural shapes.
    G-Clip model RSSGC is a 316-stainless steel grating fastener used to fasten close-mesh bar grating to structural shapes, where the structural flange is in a horizontal plane. The unit has a unique narrow width to accommodate very narrow (3/8") grating slots. G-Clip model RSSGC- fastener consists of three parts, which are assembled at the factory into a complete installation unit, packed 50 units to a standard box. Model RSSGC Info Page
  • Attach devices to grating surface

    Model GP-1 Available in Galvanized Carbon Steel. Model SSGP-1 Available in 316-Stainless Steel. The model GP-1 describes an assembly of fastener parts that can be used to fasten parallel grating panels to each other. The top part is a G-Clips unique top for better holding strength and to suit 19W4 grating. Second, a G-Clips patented bottom bar connects between the grating panel underside and projects sideways under the second grating panel. A hex-headed cap screw connects the two, and its length suits the grating height being installed Use of this model can reduce the deflection that often occurs when a single grating panel deflects downward due to traffic, and adjacent but unconnected panels cause an inadvertent trip hazard. By combining the strength of two panels, the load is shared, and deflection is lessened. Used properly, this can reduce trip hazards.
  • Attach bar grating to flanges of angle shapes or channel shapes, where the flange of the shape is in a vertical plane.
    Model GA- fastener consists of three parts, which are assembled at the factory into a complete installation unit, packed 50 pieces into a standard box. The principal part is the lower body assembly, a J-shaped assembly with a female thread, which hooks under the underside of (vertical) structural shape. The second part is the stamped top, which fits over the grating upper surface. The body and top are joined by a 1/4" - 20 threaded bolt, in proper length for the application.
  • Attach Various Bar Gratings to metal or other structural shapes. Model RGG Galvanized Carbon Steel Model RSSGG 316-Stainless Steel G-Clip model RGG is a grating fastener used to fasten bar grating to metal or other structural shapes, where the structural flange is in a horizontal plane. The model "R" top is a circular-shaped top, 2-1/8" diameter, 16 -gauge stamped steel, in the shape of a shallow volcano. A dimpled center allows hex-head cap screw to fit into the recess. Fits many odd-shaped grating bar setups.